GATEWAY M-6801M M-6802M Laptop CPU Cooling Fan AB6705HX-TB3

100% High Quality GATEWAY M-6801M M-6802M Laptop CPU Cooling Fan

Specification:
Unit: 1 pcs
Type: Laptop CPU Fan
Compatible with Part Number: AB6705HX-TB3（SA1）
Condition: Original Brand New
Power: DC 5V 0.40A bare fan
Info: Size (mm): 112 x 70 x 12,Wire Length: 48mm, (3 wire) 3-pin Connector
Warranty: 3 months
Remark: Tested to be 100% working properly.

Fit Laptop Models:

GATEWAY M-6000,
GATEWAY M-6305,
GATEWAY M-6307,
GATEWAY M-6308,
GATEWAY M-6309,
GATEWAY M-6312,
GATEWAY M-6315,
GATEWAY M-6316,
GATEWAY M-6317,
GATEWAY M-6318,
GATEWAY M-6750,
GATEWAY M-6750H,
GATEWAY M-6752,
GATEWAY M-6755,
GATEWAY M-6801M,
GATEWAY M-6802M,
GATEWAY M-6803M,
GATEWAY M-6804M,
GATEWAY M-6805M,
GATEWAY M-6806M,
GATEWAY M-6808M,
GATEWAY M-6809M,
GATEWAY M-6810M,
GATEWAY M-6815,
GATEWAY M-6816,
GATEWAY M-6817,
GATEWAY M-6821B,
GATEWAY M-6822,
GATEWAY M-6823,
GATEWAY M-6823A,
GATEWAY M-6824,
GATEWAY M-6825J,
GATEWAY M-6826J,
GATEWAY M-6827J,
GATEWAY M-6828B,
GATEWAY M-6829B,
GATEWAY M-6834,
GATEWAY M-6839J

* 100% Q.C. of GATEWAY M-6801M M-6802M Laptop CPU Cooling Fan.

How to Replace a GATEWAY M-6801M M-6802M Laptop Fan?

Heat can build up quickly inside of a laptop because of the small amount of space. The fan ventilates the hot air out of the computer, allowing the electrical components to work without heat damage. If the fan on a laptop stops working, it can be replaced with a few tools. Methods of replacement vary depending on the laptop model, so refer to the service manual included with your laptop, if necessary. Repair this problem quickly to avoid overheating and failure of your laptop.

1. Turn off the computer and disconnect any electrical devices. Remove the battery and ground the computer, according to the service manual.

2. Remove the system board, according to the service manual. The method of removal varies depending on the type of laptop.

3. Disconnect the Gateway fan connector, and remove the screws while holding the GATEWAY M-6801M M-6802M Laptop Fan in place on the system board. Remove the fan.

4 Place the new Gateway laptop CPU fan onto the system board where the old one was removed. Line up the screw holes. Use a screwdriver to replace the screws and secure the fan into place.

5 Plug the GATEWAY Fan connector into the system board.

6 Assemble the laptop, according to the service manual, and turn it on. Listen for the GATEWAY M-6801M M-6802M Laptop fan to make sure it runs properly.